Every yacht should have jacklines for keeping sailor onboard while working on the foredeck. It is also a common sense that you have to be clipped on it while sailing. I’ve followed many discussions about the tightness of jacklines. Some say that it must be as tight as possible. Others leave half a metre slack for easier moving on the deck.

Recently Yachting Monthly magazine tested what happens if the tether is so long that one goes overboard despite of being clipped on. The results were devastating. Even if the doll was wearing a lifejacket, the boat speed dragged the unfortunate sailor face down and at typical sailing speed of 5 – 6 knots the water would have been rammed down the victim’s throat.

Thus the answer is that there can be slack in jackline but not as much as the clipped tether would allow one be dragged alongside the moving boat.

Jacklines should also be inspected regularly as the webbing is probably made from polyester and prone to deterioration in the Sun’s ultraviolet radiation. Webbing’s attachment points and fittings need also to be strong enough to hold the load and prevent an accident.

The load on jacklines is huge because of simple force multiplies in the jackline rigging. Here is a calculator for the strength of force of yacht’s jacklines. Please note that this calculator is the ideal case. In the real world the knots and splices are weakening the line. For example the bowline weakens the line about 30 % – 40 %. In addition you should use a safety factor. Do not use a line with a breaking load of 2000 kg if the calculation below gives a result of 2000 kg!

Sailor’s weight: kg

Jackline’s length: m

Jackline midpoint’s slack from deck: m

Shock load multiplier:
This depends on how high one intends to go overboard 🙂 I estimate that 3 would be a good value for counting your weight in triple in falling over.

Jackline shock load at both ends: kg

Jackline load formula
Jackline load formula

So how do I test that Suwena’s jacklines are strong enough? Simple. I hold from the middle of the jackline with both hands and use my whole body weight together with a body swing to give it a good pull. If I go overboard then it is much better to happen in the marina 🙂 If not then all is in working order.

Shock Load Calculator for Yacht Jacklines

2 thoughts on “Shock Load Calculator for Yacht Jacklines

  • May 26, 2015 at 19:08
    Permalink

    Hienoa, pitää ottaa mitat kun
    Hienoa, pitää ottaa mitat kun laitamme elämänlangat ja syöttää ne laskuriin. Tmu voisi kyllä testatakin… Satamassa.

    Reply
    • May 27, 2015 at 17:56
      Permalink

      Kertokaahan Teemun
      Kertokaahan Teemun testituloksista sitten, että pääsikö Teemu uimaan? Onneksi Sarasteella on aina kaksi meripelastajaa mukanaan. t Eve

      Reply

Leave a Reply

Your email address will not be published.